Operator`s manual

INSTRUMENTS AND CONTROLS
124
Recirculation
Press recirculation to circulate the air in the cab. Only a small amount
of air is taken directly from outside.
The light in the button comes on when the button is pressed for air
recirculation.
Temperature Control Settings MCC
Cool and Hot Temperature Settings
Move the knob to the blue bar for cool air to circulate in the cab, and to
the red bar for warm to hot air to circulate in the cab. Select the desired
fan speed starting from 1 to 4. “0” is not a fan speed.
Mist and Ice Removal
DO NOT attempt to drive with the windshield
covered by mist, or fog or frost. The visibility is
reduced, which could lead to an accident causing
severe personal injury or death.
1. Turn knob to defrost.
2. Rotate the temperature knob to add heat as necessary.
3. Set the fan to maximum (the extreme right).
Use these instructions to keep the windshield clear at all times.
Maximum heat output for fast defrosting can only happen after the
engine has reached operating temperature.
While driving in extreme cold, adding heat to the windshield may
change drifting snow to ice, in this case, setting the air distribution to
floor and/or panel only may allow the drifting snow to be brushed off
by the windshield wiper.
Clean the inside of the window using normal window cleaner in order to
minimize the risk of misting. Clean more often if a passenger smokes in
the cab.
vn-vhd.bk Page 124 Tuesday, July 1, 2008 9:44 AM