Operator`s manual

OPERATION
257
Operating the Safety Belt
To fasten the safety belt, pull the belt out from the retractor and insert
the latch into the buckle. Verify proper lock of the latch by pulling on the
latch.
Adjust the slack by pulling on the top part of the belt until the lower
part, or the part that crosses the lap, is adjusted to fit “snug.” Release
the top part and let the retractor pull the belt in.
The lap portion of the safety belt should be worn low across the pelvic
region (hip bone) and adjusted snugly. Never adjust the lap belt across
the abdomen. A push button on the buckle is used to release the safety
belt latch by pushing in the button release on the buckle.
vn-vhd.bk Page 257 Tuesday, July 1, 2008 9:44 AM