Operator`s manual

OPERATION
309
Engaging
The cruise control switches are located on the turn signal lever.
To engage and set desired speed:
1. Set the cruise control switch to ON.
2. When the desired vehicle speed has been reached, momentarily
press in the SET+ or SET- switch on the end of the lever.
3. To increase speed, press the SET+ switch. A momentary press of
the switch (half second or less) will bump up vehicle speed in small
increments. Hold down the switch (more than a half second) to
ramp up vehicle speed. The vehicle speed will increase as long as
the SET+ switch is pressed (speed will not increase above the
maximum programmed speed). Release the switch when the
desired speed has been reached. The new set speed will be the
vehicle speed when the switch is released.
4. To decrease speed, press the SET- switch. A momentary press of
the switch (half second or less) will bump down vehicle speed in
small increments. Hold down the switch (more than a half second)
to ramp down vehicle speed. The vehicle speed will decrease as
long as the SET- switch is pressed (speed will not decrease below
the minimum programmed speed). Release the switch when the
desired speed has been reached. The new set speed will be the
vehicle speed when the switch is released.
vn-vhd.bk Page 309 Tuesday, July 1, 2008 9:44 AM