Operation Manual
03 Planning your trip
Settings
03
``
55
Route proposal
When the Start guidance command has been
given, two alternatives will be presented:
•
Select 1 to let the navigation system
choose the most suitable type of route
•
Select 3 and the system will present up to
3 route proposals (if more than one possi-
bility is available) to choose from
See page 50 for more information.
Route options
1
Customize route.
Select roads or other things that the system
should avoid as far as possible when setting a
route:
•
Avoid highways
•
Avoid toll roads
•
Avoid ferries
•
Avoid unverified roads
•
Avoid borders
•
Avoid time-restricted roads
•
Avoid season-restricted roads
NOTE
•
If a route has already been set when one
or more of these alternatives are
changed, there may be a slight delay in
guidance as the system recalculates the
route.
•
If the system has been set to avoid toll
roads, highways, etc., roads of this type
will only be used when there are no
other alternatives.
Route learning
An itinerary must be set. If the driver has acti-
vated an itinerary and then takes another route
to the final destination than the one proposed
by the system, the system will memorize the
roads that the driver has chosen.
If the same itinerary is selected two more times
and the driver uses "his/her own route" again,
the system will show the driver's route.
If this alternative is marked and the same route
is driven three times, this new route will be
stored and replace the original itinerary.
Reset route learning
This deletes the "learned" route.
1
These options vary, depending on the area/market/state.