Installation Guide

921018-00
PAGE NO.
1 of 2
Copyright © 2004 Ingersoll-Rand.
All rights reserved.
210K TRIM
REVISION
9
INSTALLATION INSTRUCTIONS
1. Prepare door for exit device. See
exit device instructions for holes
and center lines.
2. Prepare door for trim:
A. Transfer vertical center line from
inside (exit device side) of door
to outside (trim side) of door. Use
extra care if edge of door is
beveled. Be sure vertical center
line is parallel to edge of door.
B. Locate and prepare holes as
shown.
3. Apply trim. Cylinder must be in
position shown in Figure 1 with key
removed. See opposite side for 2-1/4
thick doors.
4. Apply device and thru-bolt to trim.
LHR shown, RHR opposite
For cutouts on inside face of door, see exit device instructions
2-1/4
3-3/8
1-1/4
5/8
13/32 dia.
this side
4 places
Vertical center line corresponds to vertical center line on exit device instructions
Metal door: 1/4 dia.
4 places
Corresponds
to center line
of exit device
on exit device
instructions
C
L
Outside face
of lock stile
Inside face
of lock stile
Metal
door
Wood
door
2-1/4 dia.
this side
Outside face
of lock stile
1-1/4
5/8
1-11/16
3-3/8
2-3/4
13/32 dia.
thru, 4 places
1/4 rad. max. typ.
C
L
C
L
C
L
C
L
C
L
C
L
Metal door Wood door
1-11/16
Cutout thru door
Figure 1
When installing
trim, cylinder must
be in this position
with key removed
3-3/8
1-1/4
5/8
1-11/16