User guide

VT2542 Voice Gateway User Guide 7
Overview Installation Troubleshooting Contact FAQ Glossary License
Configuration: Basic Advanced TCP/IP Wireless
6 Connect the power adapter to the Power port on the rear panel of the voice gateway, and plug the other end
into an electrical outlet.
7 Turn on your computer. The Ethernet light on the VT2542 front panel should light.
8 Test your connection. Open a web browser and enter any website address (you can try www.motorola.com).
If you can access the site, you have successfully installed your voice gateway.
9 Repeat step four to connect additional devices.
If your test (STEP 8) is not successful, and you are a:
Cable Modem Users
Turn your cable modem off again for at least 10 minutes. If this does not correct your problem, you may
need to register your VT2542 with your cable provider. Please contact them to update your information. Be
sure to have the WAN MAC ID (located on the bottom of the VT2542) available. When your Internet
connection works, go to C “Connecting Your Telephone” on page 10.
IMPORTANT: Before you continue, be sure to allow enough time for your voice gateway to
complete its start-up process. VT2542 startup is complete when the Power light on its front
panel lights solid green. This usually takes a few minutes.
IMPORTANT: Before you continue, be sure the VT2542 Power, Ethernet, and Internet lights
are all on.