User Manual

6
EN
WWW.VONROC.COM
TECHNICAL SPECIFICATIONS
Model No. EH501AC
Power supply 220-240 V ~/ 50Hz
Power rating 2000W
Settings 1000/2000 W
Thermostat control
Continuously adjustable
5-65 °C
IP class IP20
Weight 1.7 kg
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. Function knob
2. Thermostat knob
3. Heater
4. Air outlet grille
5. Fan
6. Off position
7. Fan position
3. OPERATING
Check the device for damage before use
and only use in good working condition.
When using the heater for the first time, you may
notice a slight emission of smoke. This is quite
normal and it stops after a short time. The heating
element is made of stainless steel and was coated
with protection oil by production. The smoke is
caused by the left oil when heated.
Placing the electric heater
• Place the heater upright on a firm and a level
surface
• Keep a minimum distance of 1 m between the
front of the housing and walls, combustible
materials (furniture, curtains, etc.) and 30 cm
from all other housing surface areas. Keep away
from wet environments.
Warning! Make sure to place the heater in
a safe spot, so you cannot easily trip over
the machine and cable. Make sure to place
the heater where it cannot fall down / of.
Starting the electric heater
• Plug in the cable to the mains
• Set the thermostat knob (2) to the Max
• The heater will switch on when the function
knob (1) is set to one of the 3 power settings.
• Temperature can be set by turning the thermo-
stat knob (2) to min or max.
Constant room temperature
Once the room reaches the required temperature,
heating element and fan will stop running.
Once the temperature decreased, the heating
element and fan will start again.
The heater now starts and stops automatically and
therefore keeps the room temperature constant.
Automatic Overheat Safety Control
This heater is equipped with safety internal heat
limiting thermostat and overheat protection circuit.
When a potential overheat temperature is reached,
the system will automatically shut the heater off.
Stopping the electric heater (Fig. B)
Let the machine cool down before turning
off by using the ventilation function.
• Turn the thermostat knob (2) to MIN position
and turn the function knob to fan position (7).
• Let the fan cool down the appliance for a few
minutes
• Turn the function knob (1) to off position (6).
• Pull the plug out of the mains
Storing the electric heater
• Always let the heater cool down completely
before storing the machine.
• Never wrap the cable around the heater
Warning. Never store the machine in a wet
or dusty environment.
After long storage always make sure the heating
element is clean and free from dust.
4. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.