User Manual

DIGITAL MUSIC CORPORATION 13
1. Enter Setup Mode by pressing both Ground Control [SETUP MODE] buttons at the
same time.
2. Press [EXPANDERS].
3. Press [+/YES] so the display reads "GCX-1 ON".
4. Press [CURSOR
>] to access the first loop. To use this loop as an audio loop or a
latched switch, press [-/NO] so the display reads "GCX 1=NORMAL". To use this
loop as a momentary switch, press [+/YES] so the display reads "GCX 1=MOM SW".
5. Repeat step 4 for each of the eight loops.
6. If you have additional GCX modules, press [SELECT
∨] to select GCX-2 and repeat
the above.
7. Exit Setup Mode by pressing either [SETUP MODE] button. When the display reads
"EXIT Y/N", press [+/YES].
You can now check if you have correctly configured the Ground Control. First turn off
both Ground Control and GCX with the GCX power switch. Then turn power back on.
After the Ground Control finishes its startup message the Active LED on the GCX will
blink and then stay on. This indicates that the Ground Control and GCX are successfully
communicating.
Controlling GCX Loops
Now that you have setup your Ground Control to access the GCX, you can easily control
each of the eight loops.
1. Press [SELECT
∨] until the Ground Control display reads "GCX-1".
2. Pressing [1] through [8] will control GCX loops. The Status LED's on the GCX front
panel, and the LED next to each button on the Ground Control will show the current
status of each loop.
Creating and Recalling Presets
For detailed information on programming, saving, and recalling Ground Control presets,
please refer to the Ground Control User's Guide.