Installation manual

5. Startup DCR 6024/6128/6000
5 – 6
Planning and Installation – Rev. 1 / 7. 2001
5.4 CONTROL OF THE INPUT / REFERENCE SIGNAL
5.4.1 DTV MODE
Select the connected video input signal and/or the reference signal in the VIDEO
menu as reference source.
Since the machine can also be operated with an internal reference signal, it is only
necessary to select a reference if the machine is operated in conjunction with other
machines (please refer also to Operating Instructions section 4.11.2 ”VIDEO menu,
Setup REFERENCE”).
F 1 F 2 F 3 F 4 F 5 F 6 F 7 F 8 F 9 F 10 F 11 F 12
Fig. 505: DTV Video menu
Note:
In Record mode the machine is always synchronized with the selected video
inputsignal. Only in Play and Crash Record mode (operating instructions
section 4.5. ”EDITOR”) the machine is synchronized with one of the signals
selected in the VIDEO menu with the SETUP and REF keys.
The following signals can be selected at the Control Panel:
INTERNAL selected when no external reference is present or needed (Free
run mode)
EXTERNAL selected when an external analog reference is present (EXT
SYNC)
VIDEO IN Digital Video Input dependent on Setup Input, refer to operating
instructions section 4.11.1.
Reference inputs
Synchronization