Installation manual

Safety InstructionsDCR 6024/6128/6000DCR 6024/6128/6000
III
Planning & Installation – Rev. 1 / 7. 2001
The signal Processors DTV 6024 and DDP 6128 and Data Switch DSW 6000 are
protected by an automatic fuse, which is located on the Processor rear panel.
The DCR 6024/6128/6000 may only be operated in closed condition.
Opening the covers or removing parts with tools may give access to live parts.
Therefore the system must be completely disconnected from the mains before any
cover is opened.
If, however, working on the opened machine is inevitable, this may only be done by
an expert who is familiar with the dangers involved.
Beware of high speed rotating video heads.
Wear safety glasses!
Warning !
ATTENTION! Capacitors may still be charged!
If, for example due to a failure, safe operation of the DCR 6024/6128/6000 is no
longer possible, take the unit out of operation and secure it against further use.
The Tapedeck contains two backup batteries type Varta CR 1/2 AA Thomson
part no. 003 119 100 195 which have to be replaced with batteries of the same
type (UL-1642 listed).
Battery replacement should be done by Thomson service personnel only.
Fuse of
Processor
During operation
Working on the
opened machine
Capacitors
Batteries