User's Manual

ManualsBrandsVornado ManualsOutdoor Ceiling FanVornado 7803

10 English

Grill and Blade Removal

WARNING: To avoid risk of ﬁre, electrical shock, or injury to persons,

unplug the Air Circulator before removing the grill.

Grill: Using a phillips head screw-

driver, remove grill by unscrew-

ing the 4 screws located along

the perimeter of the inlet grill at

roughly 2, 5, 7, and 11 o’clock posi-

tions. This will release the grill. To

reattach, position grill so the logo

in the center of the grill is straight.

Models 5303, 6303, 7503, 7803,

align the Locator Pin (A) to reconnect

grill. Once aligned replace screws.

Model 1303, align the Alignment Rib (B) to reconnect grill. Once

aligned replace screws.

To clean motor cap and inlet ribs: Use

a common household vacuum. Do not

use water to clean these parts of the Air

Circulator.

To clean grill: Remove grill (See GRILL

REMOVAL instructions) and dust or wash

with a mild dishwashing soap. Do not

place grill in the dishwasher. The exces-

sive heat can distort the plastic.

To clean blade: Wipe with a damp cloth.

If your Air Circulator is used in a greasy

environment, such as a kitchen, mild soap

or a common household cleaner may be

necessary. Do not use solvents.

To clean base: Wipe with a damp cloth.

Because your Air Circulator moves a substantial amount of air, it will

need regular cleaning. To avoid risk of ﬁre, electrical shock, or injury to

persons, unplug the unit before any cleaning activity.

The motor is permanently lubricated and requires no

oiling.

Cleaning and Maintenance

Blade: It is possible to remove the blade

should something accidentally get wrapped

around the motor shaft. First, remove the

nut from the shaft. Turn the nut clockwise to

loosen. Pull the blade straight out from the

shaft. When replacing, the blade can only

go on the shaft one way. Be certain the ﬂat

side of the shaft aligns directly with the cor-

responding ﬂat side on the blade’s socket.

Push the blade all the way on the shaft until

it bottoms out. Do not use a hammer as this

could result in bearing damage. Reinstall nut.

Remove the Nut