Use and Care Manual
11
English
Problem Possible Cause and Solution
Troubleshooting
Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker / ground fault circuit interrupter has tripped or blown fuse. Reset circuit breaker /
ground fault circuit interrupter, or replace fuse. See IMPORTANT INSTRUCTIONS.
Unit has overheated. Automatic Safety Shut Off has initiated. See RESET HEATER.
Internal tip-over switch has been tripped and safety shut-off system has cut power to heater. Place heater on
level surface. See SAFETY FEATURES.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Ensure unit is set to Whole Room High Heat or Personal Zone Heat and set temperature at highest setting.
Close all doors and windows to trap heat.
Allow unit to fully circulate heat throughout a room; may take several minutes.
Check lter and clean as necessary. See CLEANING.
Unit fails to power on.
Unit is not producing
sufcient amount of heat.
Airow is diminished.