SDS

Li-MnO2 Button Cell(Lithium Metal Battery) CR2032
Safety Data Sheet
This document has been prepared in accordance with the SDS requirements of the OSHA Hazard Communication Standard 29 CFR 1910.1200
22/08/2019
EN (English US)
4/10
7.2. Conditions for safe storage, including any incompatibilities
Storage conditions
:
Store in a cool and dry area, but prevent condensation on cell or battery terminals.
High temperature may damage the performance of the battery.
Protect from physical damage and short circuits.
To avoid risk of fire or explosion, keep sparks and other sources of ignition away from the
battery.
Do not allow metal objects to simultaneously contact both positive and negative terminal of
batteries.
Do not stack battery directly on another battery.
Do not store batteries on electrically conductive surfaces.
Keep containers tightly closed in a dry, cool and well-ventilated place (-20 - 45 °C ，humidity:
45-75%)
Keep locked up and out of reach of children
Keep away from food, drink and animal feeding stuffs
Store in accordance with local regulations
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Stainless steel (12597-68-1)
Not applicable
Polypropylene (9003-07-0)
Not applicable
Manganese oxide (MnO2) (1313-13-9)
Not applicable
Lithium (7439-93-2)
Not applicable
Perchloric acid, lithium salt (7791-03-9)
Not applicable
Polytetrafluoroethylene (9002-84-0)
Not applicable
Graphite (7782-42-5)
ACGIH
ACGIH TWA (mg/m³)
2 mg/m³ (all forms except graphite fibers-respirable
particulate matter)
OSHA
OSHA PEL (TWA) (mg/m³)
15 mg/m³ (synthetic-total dust)
5 mg/m³ (synthetic-respirable fraction)
IDLH
US IDLH (mg/m³)
1250 mg/m³
NIOSH
NIOSH REL (TWA) (mg/m³)
2.5 mg/m³ (natural-respirable dust)
Propylene carbonate (108-32-7)
Not applicable
Ethylene glycol dimethyl ether (110-71-4)
Not applicable
8.2. Appropriate engineering controls
Appropriate engineering controls
:
Ensure good ventilation of the work station. Emergency eye wash fountains and safety showers
should be available in the immediate vicinity of any potential exposure. Remove all sources of
ignition.
Environmental exposure controls
:
Avoid release to the environment.
8.3. Individual protection measures/Personal protective equipment
Hand protection:
Under normal condition of use and handling no special protection is required for sealed battery. In the event of battery case
breakage, should be wear appropriate safety gloves
Eye protection: