Use and Care Manual

English

REMOTE CONTROL

BATTERY REPLACEMENT Screwdriver required.

1. For battery replacement, the remote requires one coin style 3V

CR2032 battery. Always use the correct size and grade of battery for

this product.

2. To replace battery, open battery door on the back side of the

remote control (you will need to loosen the small screw on door

using a #1 Phillips screwdriver). If necessary, clean the battery

contacts and also those of the device prior to battery installation.

Remove any plastic protection from the battery and place it

in the remote with the + side facing out. Ensure the battery is

installed correctly with regard to polarity. Replace the battery door

and screw.

Note: Remove battery from the remote control when not in use for an

extended period of time and always remove dead battery immediately

and replace with fresh. Do not store dead battery in remote.

Your circulator remote includes (1) coin style 3V CR2032 battery. Bat-

tery comes pre-installed. Remove battery pull tab before rst use.

WARNING: This product contains a button battery. If swallowed,

it could cause severe injury or death in just 2 hours. Seek medical

attention immediately.