Use and Care Manual
9
English
Note: Spills can occur during cleaning, moving or relling the Water
Tank, so be careful to avoid spills when doing these activities.
1. Unplug humidier and place on a level surface.
2. Remove Water Tank from the base by grasping the top integrated
handle and pulling up towards you (A). CAUTION: When
removing Water Tank lift vertically, do not twist tank while still
in base or Cap may disengage and leak.
3. Turn the Water Tank upside down and remove the Cap by turning it
counterclockwise (B).
4. Gently place Water Tank on a at surface and ll with cool tap
water.
5. Ensure Gasket, the rubber ring around the Water Tank, is properly
positioned. Insert the Cap into the grooves of the tank and turn
clockwise until tightened. When Cap is fully tightened the arrows
on the tank will align with the indicator lines on the Cap (C).
6. Lower Water Tank into Base, positioning Water Tank around the
ledge for secure placement (D). Once in nested position, water
outlet valve inside Cap opens, releasing water into Base.
Note: When the Water Tank level is low, the light on the side of the
humidier will pulsate until it is relled. This feature can be turned
off and on by holding both the - / + buttons for ve seconds. This
function does not apply when in Continuous (CO) mode.
FILLING WATER TANK
C
A B
D
²
²
²
Gasket Ring