Warranty

9
English
1. The round inlet cone (connects to the inlet grill on back of heater)
can be used for lifting and carrying the heater.
2. Position heater so airflow is not obstructed.
3. Plug power cord into standard grounded wall outlet.
4. Adjust the tilt of the pivoting head for multi-directional airflow.
5. Use toggle switch to select Low Heat or High Heat. Red power
indicator light located on front at base of heater illuminates to
indicate the heater is On. Set thermostat to highest setting by
turning clockwise. When room reaches desired comfort level, turn
thermostat slowly counterclockwise until heat cycles off.
6. If heater tips over, power will be cut to heater. The red indicator
light will not illuminate until you position the heater back in upright
position and power is restored.
NOTE: Use caution after the heater has been in use as the metal
outlet grill and pivoting head may be warm to the touch.
Before use, check appliance for visible damage. DO NOT USE THIS
HEATER if there is evidence of damage. If any damage is found,
contact Vornado Air LLC at 1-800-234-0604.
HOW TO USE