User's Manual

P/N: 4HS020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
27JUL04 v2.0 S2000 (4HSv2.0)
REMOVE FACTORY
SCREWS
13
8. SUPERCHARGER MOUNTING BRACKET/PLATE INSTALLATION, cont’d.
DO NOT INSTALL HARDWARE
IN THIS HOLE AT THIS STEP
M12 x 1.75 x 50mm SCREW WITH
WASHER INSTALLED THROUGH
SUPPORT PLATE AND Ø1.0 x .549
SPACER AND INTO SUPERCHARGER
BOSS (SPACER SANDWICHED
BETWEEN CENTER SUPERCHARGER
BOSS AND SUPPORT PLATE)
3/8-16 x 1.25 SCREW
WITH AN WASHER
3/8-24 x 3.5" SCREW/
BEARING PILOT
INSTALLED THROUGH
RIBBED IDLER AND
SPACER AND INTO
THE NUT INSTALLED
IN THE MAIN PLATE
(SEE SIDE VIEW)
BELT TENSIONER
ADJUSTMENT SCREW
AND LOCATOR BLOCK
(LOCATED ON OPPOSITE
SIDE OF PLATE) ATTACHED
WITH TWO 1/4-20 x .75
SH SCREWS THREADED
IN FROM THIS SIDE
OF MAIN PLATE
MAIN SUPERCHARGER
MOUNTING PLATE
1/2-20 BELT TENSIONER
ARBOR SCREW
INSTALLED (FROM
OTHER SIDE)
THROUGH MAIN
PLATE IDLER SPACER
SMOOTH IDLER - M12
x 10" THICK WASHER
AND 1/2-20 JAM LOCK
NUT (SEE SIDE VIEW)
MAIN SUPERCHARGER MOUNTING PLATE
VIEW FROM BACKSIDE
(DASHED LINES REVEAL HIDDEN VIEWS)
Fig. 8-e