User's Manual

P/N: 4HS020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
27JUL04 v2.0 S2000 (4HSv2.0)
19
3/8-16 x 3.5” SCREW / AN WASHER
INSTALLED FROM THE BACKSIDE
THROUGH SUPPORT PLATE AND
Ø.875 x 1.858 SPACER AND INTO
UPPER SUPERCHARGER MOUNTING
BOSS (SPACER SANDWICHED BETWEEN
MAIN PLATE AND SUPPORT PLATE)
M6 1.0 x 80mm SCREWS
THROUGH VTEC SOLENOID
(NOT SHOWN), SUPERCHARGER
PLATE MOUNTING BLOCK
AND INTO CYLINDER HEAD)
CYLINDER HEAD
M10 x 1.25 x 50mm SCREW
WITH WASHER THROUGH
SUPERCHARGER PLATE MOUNTING
BLOCK AND INTO CYLINDER HEAD
SUPERCHARGER PLATE
MOUNTING BLOCK
M12 x 1.75 x 50 SCREW
FACTORY FIXED IDLER
PRE-INSTALLED 3/8-24
“PRESS NUT” INSERT (3 PLACES)
M12 WASHER
Ø1.0” x .549 SPACER
SUPERCHARGER
SUPPORT PLATE
FRONT FACE OF
ENGINE BLOCK
SUPERCHARGER BRACKET ASSEMBLY VIEW FROM PASSENGER SIDE —
VORTECH IDLERS AND SOME FASTENERS NOT SHOWN FOR CLARITY
(DASHED LINES REVEAL HIDDEN VIEWS)
LOWER SUPERCHARGER PLATE SPACER
(ROUND PROTRUSIONS TO BE INSTALLED
AGAINST THE FRONT COVER)
SUPERCHARGER
MOUNTING PLATE
M6 x 1.25 x 1.15 SCREW
THROUGH MAIN PLATE.
Ø1.0 x 2.726 SPACER
FACTORY IDLER AND
INTO FACTORY
THREADED IDLER
MOUNTING HOLE
ON FRONT COVER
3/8-24 x 3.5’ SCREWS
INSTALLED FROM THE
FRONT THROUGH MAIN
PLATE AND Ø.875 x 1.858
SPACERS AND INTO
SUPPORT PLATE, SPACERS
SANDWICHED BETWEEN
MAIN PLATE AND SUPPORT
PLATE — 3 PLACES)
CENTER M12
SUPERCHARGER BOSS
3/8"
WASHER
Ø1.0" x 2.726
STEEL SPACER
M10
WASHER
M6 x 1.0 NUTS WITH WASHERS INSTALLED
ONTO STUDS PREVIOUSLY THREADED
INTO FRONT OF ENGINE
1.858
2.726
.549
8. SUPERCHARGER MOUNTING BRACKET/PLATE INSTALLATION, cont’d.
Fig. 8-o