User's Manual

P/N: 4HS020-010

27JUL04 v2.0 S2000 (4HSv2.0)

located on the supercharger cover.

4. Two 3/8-16 x 1.25" screws with AN washers

that attach the supercharger support plate

to the supercharger mounting block.

5. M10 x 1.25 x 115 screw through the front of

the supercharger mounting plate and into

the factory idler pulley mount on the front

cover.

6. Two 5/16-18 x 1.0" screws through the su-

percharger mounting plate and into the lat-

eral support.

7. Two M8 x 1.25 x 45 socket head screws

through the lateral support mounting plate,

front corner of the cylinder head and into the

front cover.

8. Three 3/8-24 x 3.5" screws running through

the main mounting plate, Ø.875 O.D. x

1.858" long spacers and into the threaded

steel inserts that are pressed into the back

side of the support plate.

9. Two M6 nuts that are threaded onto the two

studs inserted into the front of the engine.

X. Repeat the sequence above with final torquing of

all hardware.

Y. Reconnect the previously removed VTEC wiring

connections.

Z. Reattach the plastic vacuum canister to the back-

side of the front crossmember (located in front of

the engine) using the factory screw that was

removed in step 1. Make sure that there is

enough clearance between the vacuum hose

and the crank pulley.

8. SUPERCHARGER MOUNTING BRACKET/PLATE INSTALLATION, cont’d.

Fig. 8-x

TWO M8 x 1.25 x 45

SOCKET HEAD SCREWS

(NO WASHERS)

TWO 5/16-18 x 1"

SCREWS WITH

AN WASHERS