Owner's manual

P/N: 4GE020-010 v4.0, 2012-12-12
©2012 Vortech Engineering, INC
All Rights Reserved, Intl. Copr. Secured
6
J. Use a 15mm wrench or socket to release the
tension from the 6-rib belt with the OEM belt
tensioner as shown in Fig. 1I. Remove the
belt and set aside for reinstallation in a later
step.
K. Remove the three (3) 13mm-headed screws
securing the power steering pump to its cast
mounting bracket (through the holes in the
pulley) and set them aside for later reuse.
Lay the pump aside as shown in Fig. 1J,
leaving the lines attached.
L. Remove the three (3) 15mm-headed bolts
securing the cast power steering bracket to
the cylinder head. The cast bracket and fas-
teners will not be reused.
M. Remove the 15mm-headed screw from the
alternator shown in Fig. 1K. It will not be
reused.
Fig 1I
Fig 1J
Fig 1K
REMOVE
NOTE: 2013 models only: 2013 models are not equipped
with a P/S pump. Remove the cast idler bracket
assembly from the cylider head and set aside.