Owner's manual

P/N: 4GE020-010 v4.0, 2012-12-12
©2012 Vortech Engineering, INC
All Rights Reserved, Intl. Copr. Secured
8
Q. Drain the engine coolant into a clean contain-
er to be reused in a later step. There is a
drain valve at the driver side bottom of the
radiator, and removing the radiator cap will
improve flow.
R. Once the coolant is drained, remove the fac-
tory clamps securing the upper radiator hose
at the engine and the radiator. Remove the
clamp that secures the 5/8" hose located on
the driver side of the harmonic balancer. Set
hoses aside to be modified in a future step.
See Fig 1N.
S. Locate the windshield washer reservoir
(under the driver side headlight) and discon-
nect the electrical connector from the pump.
T. Drain the reservoir by removing the pump
from its grommet and retaining saddle and
catching the fluid in a large, clean open con-
tainer or funnel as shown in Figure 1O.
Keep the fluid for later reuse. Remove the
washer hose from the 90º fitting near the
pump and free it from the attachment points
on the reservoir. Remove the grommet from
the reservoir and retain for later use.
U. Remove the three (3) 13mm-headed screws
mounting the windshield washer reservoir
and set the reservoir aside. It will be
replaced in a later step.
V. Disconnect the small hose near the cap of
the engine coolant reservoir located on the
passenger side, opposite the windshield
washer reservoir. Remove the two (2)
13mm-headed screws mounting the coolant
reservoir and set the reservoir aside. It will
be replaced in a later step.
Fig 1O
Fig 1N