Owner's manual

P/N: 4GE020-010 v4.0, 2012-12-12
©2012 Vortech Engineering, INC.
All Rights Reserved, Intl. Copr. Secured
9
W. Remove the steel power terminal mounting
bracket from the driver side strut tower as fol-
lows:
a. Center punch each spot weld securing
the bracket to the strut tower as shown
in Figure 1P.
b. Use the supplied Rotobroach tool to drill
each spot weld and remove bracket (see
Fig. 1Q).
c. Use a file or grinder to clean up the
remainder of the spot welds and touch
up with paint of your choice to prevent
corrosion. The area will be hidden when
supercharger installation is complete.
X. Remove the 4-rib A/C stretch belt by rotating
the crankshaft clockwise with a 15/16” or
24mm socket while pushing the belt toward
the rear of the vehicle as shown in Fig. 1R.
Fig 1P
Fig 1Q
Fig 1R
NOTE: Be sure to place manual transmission cars in
neutral.