Owner's manual

P/N: 4GE020-010 v4.0, 2012-12-12

A. Remove the fuel tank cap. Relieve the fuel

system pressure at the fuel rail by carefully

depressing the schrader valve. Use a rag to

cover the valve to avoid fuel spray. See Fig

3A.

B. Disconnect the eight fuel injector wiring clips

and metal retainers from the injectors. See

Fig 3B.

C. Remove the fuel rail assembly as follows:

i. Remove the nut securing the black plas-

tic engine cover support to the rear sec-

tion of the intake manifold. Pivot the

support upward and snap it off of the

passenger side fuel rail.

ii. Remove the nut securing the fuel feed

line to the front passenger side fuel rail

stud.

iii. Remove the screw securing the small

bracket that sandwiches the front driver

side fuel rail mounting tab.

iv. Remove the safety clip and disconnect

the fuel feed line from the fuel rail

assembly using the appropriate discon-

nect tool. Take care to absorb any fuel

spillage.

v. Remove the four (4) 10mm-headed stud

screws securing the fuel rail assembly to

the intake manifold.

vi. Lift up on the rails evenly and remove

the assembly, complete with the fuel

injectors, from the vehicle.

Fig 3A

Fig 3B

3. FUEL INJECTOR REPLACEMENT

NOTE: Caution should be used when working on the fuel

system. Fuel may be under high pressure. Fuel

injector replacement should be performed in a well

ventilated area free of any possible ignition source.

It is recom mended that you have a fire extinguisher

nearby.