Owner's manual

P/N: 4GE020-010 v4.0, 2012-12-12
©2012 Vortech Engineering, INC.
All Rights Reserved, Intl. Copr. Secured
31
R. Assemble the supplied smooth idler, M10-1.5
x 110mm screw, idler pilot spacer, and idler
pilot washer with the head of the screw on
the snap ring side of the idler as shown in
Fig. 6S. Install the idler assembly into the
lower left-hand hole in the tensioner support
plate as shown in Figure 6Q.
S. Remove temporarily installed M10-1.5 X
120mm screw and use to install the pre-
assembled spring tensioner into the upper
set of holes located on the front tensioner
plate. See Fig 6R.
Fig 6Q
Fig 6R
FIXED
IDLER PULLEY
Fig 6S