Owner's manual

P/N: 4GE020-010 v4.0, 2012-12-12
©2012 Vortech Engineering, INC.
All Rights Reserved, Intl. Copr. Secured
37
Fig 8C
E. While lining up each bracket with the front
bumper mounting holes, re-install the front
metal bumper beam with factory hardware,
sandwiching the CAC support brackets in
between. Tighten all six factory fasteners at
this time. See Fig 8C.
F. Adjust the height of the CAC so that it is par-
allel to and suspended above the lower sup-
port rail. It is helpful to set it on some ~1/4”
spacers. Tighten the 5/16-18 x 0.5” hard-
ware. See Figures 8D and 8E.
Fig 8D
Fig 8E