Owner's manual

P/N: 4GE020-010 v4.0, 2012-12-12
©2012 Vortech Engineering, INC.
All Rights Reserved, Intl. Copr. Secured
49
A. Locate the supplied air intake assembly and
configure as shown in Fig. 10A:
i. Insert one end of the supplied plastic
90º hose elbow into the supplied length
of 3/8” hose.
ii. Insert the other end of the plastic 90º
hose elbow into the small hole in the
end of the supplied air filter.
iii. Install the air filter onto the air intake
duct with the supplied hose clamp.
B. Locate the 3.5” x 4” silicone reducer sleeve
and attach the smaller end to the super-
charger inlet with the supplied #56 hose
clamp.
C. Install the complete air intake assembly into
the larger end of the reducer sleeve and
secure with the supplied #64 hose clamp.
Orient the assembly for clearance between
the air filter and the supercharger drive pul-
ley, loosening and adjusting the air filter if
necessary. See Fig. 10B.
D. Route the 3/8” breather hose to the front of
the passenger side cylinder head, routing
and securing it away from moving parts, hot
surfaces, and sharp edges.
E. Connect the 3/8” breather hose to the open
port just inboard of the engine oil filler neck
as shown in Fig. 10C.
Fig 10B
10. AIR INLET INSTALLATION
Fig 10C
ATTACH AIR FILTER
BREATHER HOSE
HERE
Fig 10A