Owner's manual

P/N: 4GE020-010 v4.0, 2012-12-12
©2012 Vortech Engineering, INC
All Rights Reserved, Intl. Copr. Secured
60
A. Reinstall the Front Bumper Cover (FBC) in
reverse order from removal making sure to
reinstall:
i. Two (2) 10mm-headed screws through
the bottom of the FBC.
ii. The FBC electrical connector located
between the passenger side driving light
and headlight. Access the connector via
the wheel well.
iii. Four (4) 10mm-headed screws and one
(1) 7mm-headed screw attaching the
FBC to the leading edge of the fender
on each side (8 and 2 total).
iv. Three (3) T20 Torx screws securing
each splash guard to the FBC (6 total).
These screws are located in the wheel
wells just forward of the front wheels
along the outer edge.
v. Two (2) plastic pins securing each
splash guard to the inner fender struc-
ture (4 total). One is adjacent to the
strut and the other is directly above the
wheel.
vi. Two (2) 10mm-headed screws and six
(6) plastic pins along the top edge of the
FBC.
B. Slowly refill the engine coolant through the
spout located at the top of the radiator, allow-
ing any air to escape as the radiator fills. Fill
the new engine coolant reservoir about 2/3
full.
C. Using the washer fluid previously drained, fill
the washer fluid via the new remote fill spout.
Fill only so that the lower tank is filled.
14. FINAL ASSEMBLY