Owner's manual

P/N: 4GE020-010 v4.0, 2012-12-12

Fig. 14A

SELECT

ARROW KEYS

IMPORTANT! To ensure trouble-free programming of your vehicle’s computer:

• Make sure the vehicle's battery is sufficiently charged.

• Turn off all accessories and close doors to prevent unnecessary drain on the battery.

• Locate “exterior” fuse panel and remove Qty 1 INFO, Qty 1 RADIO and Qty 1RADIO AMP labeled fuses. (If applicable)

• Do not attempt to program your vehicle while a battery charger is connected

• Improper battery voltage will result in failure of the programming process.

• Do not disconnect the cable or turn off the ignition during programming.

A. Reconnect the battery if previously dis-

connected.

B. Locate the vehicle’s OBD2 connector

located under the dash on the driver

side of the vehicle. See Fig 14B

C. Attach the OBD2 connector from the

Flash tool that is provided in the kit to

the vehicle’s OBD2 port. Make sure

this connector is seated all the way in

the vehicle’s OBD2 port. You don’t

want this connector to disconnect dur-

ing programming or damage may

occur to the vehicle’s ECM. See Fig

14C

15. REFLASH COMPUTER

CANCEL

NOTE: • All vehicles equipped with On-star that have

aftermarket stereos will experience problems

with the ability to re-program the vehicle’s ECM.

It is necessary to disconnect the aftermarket ste-

reo from the factory wiring harness before con-

tinuing with the programming procedure.

• Do not disturb the cable or turn the ignition off

during this time. If the programming is disrupted,

the computer will not start or run your vehicle!

Fig 14B

Fig 14C

OBD2 CONNECTOR