Owner's manual

P/N: 4GE020-010 v4.0, 2012-12-12

This supercharger has been factory pre-lled with special

Vortech synthetic lubricant. Oil does not need to be added

to a brand new unit; however a uid level check should be

performed.

Prior to operating the supercharger on the vehicle and after

installation onto the vehicle:

Remove the factory installed at-head brass shipping plug

(not the dipstick) from the top of the supercharger case.

Replace the sealed shipping plug with the supplied “vented”

plug. Do not operate the supercharger without it. Check the

supercharger uid level.

Fluid level checking procedure:

1. Ensure that the .06” copper sealing washer is locat-

ed on the dipstick base.

2. Thread the clean dipstick into the unit until it seats.

3. Once the dipstick has seated, remove the dipstick

from the unit. Fluid should register in the cross-

hatched area on the dipstick.

4. DO NOT OVERFILL!!! Drain excess fluid from the

unit if it is above the maximum level on the dipstick.

Check the uid level using the dipstick at least every 2,500

miles.

Initial supercharger uid change must be performed at 2,500

miles. The supercharger uid must be changed at least every

7,500 miles.

Drain the uid, rell the unit with 4 oz. of Vortech V3 lubricat-

ing uid and then conrm proper oil level using the dipstick.

DO NOT OVERFILL!!!

WARNING: Use of any other fluid other than the special Vortech lubricant will

void the warranty and may cause component failure.

FOR INTERNALLY LUBRICATED V-3 UNITS ONLY