Unive Batte rsal Mus tang ry Re & Ca l o ble R cation o P/N: 8 uting N150 -010 ® ENGINEERING, LLC 1650 PACIFIC AVENUE • CHANNEL ISLANDS, CA 93033-9901 • (805) 247-0226 FAX (805) 247-0669 • www.vortechsuperchargers.com • M-F 8:00 AM - 4:30 PM PST P/N: 007079 v1.
FORWARD Proper installation of this battery relocation kit requires general automotive mechanical knowledge and experience. Please browse through each step of this installation manual prior to beginning the installation to determine if you should refer the job to a professional installer/technician. Please call Vortech Engineering for installers in your area. © 2004 VORTECH ENGINEERING, LLC All rights reserved.
Battery Relocation Assembly Part No. 8N150-010 ® PARTS LIST ENGINEERING, LLC IMPORTANT: Before beginning installation, verify that all parts are included in the kit. Report any shortages or damaged parts immediately.
BATTERY RELOCATION AND CABLE ROUTING A. Disconnect and remove the battery from the vehicle. Raise the rear of the car and support it with jack-stands. B. Remove the rear seat bottom and jute pad. Remove the driver’s side scuff plate and kick panel. Remove the trunk liner, passenger’s side interior wheel well cover, plastic cover around the trunk latch and the rear trunk interior cover. C. Using a small razor knife make an opening in the factory wire harness grommet at the firewall.
BATTERY RELOCATION AND CABLE ROUTING, cont’d. H. Open the gas tank door and remove the three screws holding the filler neck using a 10mm socket. I. From beneath the vehicle, support the weight of the gas tank with a jack and remove the bolt securing the passenger’s side strap. Loosen the bolts securing the driver’s side strap to lower the tank enough to gain access to the underside trunk floor panel. NOTE: J. K. L. M. N. O. The ideal amount of fuel in the tank is 1/4 tank or less.
BATTERY RELOCATION AND CABLE ROUTING, cont’d. vertical tabs off of the hold-down bracket depending on your battery.) Secure the supplied battery hold-down bracket using 3/8-16 nuts and washers. Attach the clear hose end to the plastic 90° fitting mounted on the side of the battery box. (Refer back to Fig. 5.) P. Trim the power and ground cables to desired length, cut back the insulation and install the supplied battery end terminals.
