U CARBU NIVERSAL RETOR ENCLO SUR E ® ENGINEERING, INC. 1 6 5 0 PA C I F I C AV E N U E • C H A N N E L I S L A N D S , C A 9 3 0 3 3 - 9 9 0 1 P/N: 007051 ©2000 Vortech Engineering, Inc. All Rights Reserved, Intl. Copr. Secured 11SEP00 V 1.
FOREWORD Proper installation of this supercharger kit requires general automotive mechanic knowledge and experience. Please browse through each step of this instruction manual prior to beginning the installation to determine if you should refer the job to a professional installer/technician. Please call Vortech Engineering for installers in your area. © 2000 VORTECH ENGINEERING, INC. All rights reserved.
UNIVERSAL CARBURETOR ENCLOSURE Table Of Contents FOREWORD ...................................................................................................................... i TABLE OF CONTENTS ..................................................................................................... ii PARTS LIST ....................................................................................................................... iii CARBURETOR ENCLOSURE INSTALLATION .........................................
UNIVERSAL CARBURETOR ENCLOSURE Part No. 8M205-012/8M205-018/8M205-020 ® -012 WITHOUT FUEL LINES, SATIN/-018 WITHOUT FUEL LINES, POLISHED/-020 WITH OPTIONAL HOLLEY FUEL LINE KIT, SATIN PARTS LIST ENGINEERING, INC. IMPORTANT: Before beginning installation, verify that all parts are included in the kit. Report any shortages or damaged parts immediately. Item Description Vortech Part # Qty. Item Description CARBURETOR ENCLOSURE ASSY, WITH LINES (4150 HOLLEY LINES) .................................
CARBURETOR ENCLOSURE INSTALLATION A. Relieve the fuel pressure in the system. B. Remove the carburetor from the intake manifold. C. Thoroughly clean the intake manifold carburetor flange. D. Thread the four supplied carburetor flange studs into the intake manifold. E. Install a new carburetor gasket. F. Install the lower part of the carburetor enclosure over the studs until it sits flat on the intake manifold. G.
CARBURETOR ENCLOSURE INSTALLATION, cont’d. J. K. L. M. N. O. P. Q. R. S. T. U. V. Install the carburetor in the enclosure until it sits flat on the flange. Install two of the brass plugs in each side of the carburetor enclosure. Make sure the copper crush washers are installed between the brass plugs and the enclosure. (See Fig. 8.) Install the idle bracket on the outside of the enclosure using two 1/2” screws. (See Fig. 9.
Carburetor Enclosure Installation, cont’d. 7. Remove the barbed fittings, coat the barbs with grease, and fully insert the barbed fittings in the hose. 8. Install the fuel hose assembly and tighten all of the fuel line connections. W. Hose connections to the carburetor enclosure will vary widely depending on the application. All hoses that are not used should be plugged with the supplied -3, -8, 1/8 NPT and 1/4 NPT plugs. X.
® ENGINEERING, INC. 1650 PACIFIC AVENUE • CHANNEL ISLANDS, CA 93033-9901 • (805) 247-0226 FAX (805) 247-0669 • www.vortechsuperchargers.com • M-F 8:00 AM - 4:30 PM PST P/N: 007051 ©2000 Vortech Engineering, Inc. All Rights Reserved, Intl. Copr. Secured 11SEP00 V 1.