User Manual

P/N: 4GE020-015 v1.0, 2010-05-24
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
4
2. DAMPER & PULLEY INSTALLATION
A. Assemble the supplied ATI Super Damper
assembly as follows:
i. Insert the hub into the back of the damp-
er making sure to line up the “OFFSET
HOLE”inthehubanddamperasshown
in Fig. 2A. This hole is labeled on the
damper sticker, and there is also an indi-
cator machined into both the damper and
the hub.
ii. Install the six (6) Torx T40 flat head
screws, using blue threadlocker on each,
and torque to 16 ft-lb. See Figures 2B &
2C.
NOTE: Make sure that all mating surfaces of the
parts are clean.
Fig 2A
Fig 2B
Fig 2C