RIFLESCOPE II The Vortex® Crossfire II® Hog Hunter TM The Crossfire II Hog Hunter riflescope optimizes low light performance with a 56 mm objective and illuminated glass-etched reticle. Specifically designed for discriminating hunters with generous long eye relief, rugged construction and precise, smooth controls.
RIFLESCOPE II Riflescope Adjustments Windage and Elevation Adjustments Reticle Focus This Crossfire II riflescope incorporates adjustable elevation and windage dials with audible clicks. Each audible click moves the bullet’s point-of-impact 1/4 of a minute of angle (MOA). The Vortex Crossfire II Hog Hunter uses a fast focus eyepiece designed to quickly and easily adjust the focus on the riflescope’s reticle. Adjust the reticle focus.
RIFLESCOPE II Image Focus and Parallax Correction This Crossfire II riflescope features an image focus/parallax adjustment which provides maximum image sharpness and eliminates parallax error. Adjustable Objective What is Parallax? Parallax is a phenomenon that results when the target image does not quite fall on the same optical plane as the reticle within the scope.
RIFLESCOPE II Riflescope Mounting Eye Relief and Reticle Alignment To get the best performance from your Crossfire II riflescope, proper mounting is essential. Although not difficult, the correct steps must be followed. If you are unsure of your abilities, it would be best to use the services of a qualified gunsmith. Begin with riflescope loosely installed in rings on the rifle. Before tightening the scope ring screws, adjust scope position for maximum eye relief to avoid injury from recoil.
RIFLESCOPE II Bore Sighting Final Range Sight-In Initial bore sighting of the riflescope will save time and money at the range. This can be done in a number of ways. A mechanical or laser bore sighter can be used according to the manufacturer’s instructions. On some rifles, bore sighting can be done by removing the bolt and sighting through the barrel. After the riflescope has been bore-sighted, final sight-in should be done at the range using the exact ammunition expected to be used while shooting.
RIFLESCOPE Indexing Adjustment Dials with Zero Reset Crossfire II riflescopes feature windage/elevation dials that allow you to re-index the zero indicator after sight-in without disturbing your settings. Though not required to do, this process will allow you to quickly return to your original zero if temporary corrections are dialed in the field. Reset the windage and elevation dials in this way: 1. Remove the outer cap. While firmly holding the dial, loosen and remove center screw.
RIFLESCOPE II Troubleshooting The VIP Warranty Sighting-in Problems We build optics based on our commitment to your absolute satisfaction. That’s why Vortex products are unconditionally guaranteed and we make this Very Important Promise to you—a Very Important Person. Many times, problems thought to be with the scope are actually mount problems. Be sure that correct base and rings are being used in the correct orientation, and that the base screws and rings are tight.
