RIFLESCOPE 1 6x24 Second Focal Plane | MOA
RIFLESCOP The Vortex®Razor®HD Gen II 1–6x24 Riflescope At Vortex®Optics, the need for high-performance, precision optics is the driving force behind all that we do. We carefully built the Razor®HD Gen II riflescope to provide shooters with the ultimate short and medium range tactical riflescope.
RIFLESCOP Riflescope Adjustments Windage and Elevation Adjustments Reticle Focus Adjustment The Gen II 1–6x24 riflescope incorporates precision finger adjustable The Vortex Razor HD Gen II 1–6x24 riflescope uses a fast focus elevation and windage dials with audible clicks. eyepiece, designed to quickly To make adjustments: and easily adjust the focus on the Elevation Adjustment Dial 1. Remove outer caps. riflescope’s reticle. 2.
RIFLESCOP Variable Power Adjustment Illumination Adjustment To change the magnification, turn the magnification ring to the The Razor HD 1–6x24 riflescope uses an illuminated central dot to desired level. aid in low light performance. Illumination intensity levels will vary from bright to very low intensity.
RIFLESCOP Riflescope Mounting Rings and Bases To get the best performance from your Vortex Razor HD Gen II Following the manufacturer’s instructions, mount high quality base riflescope, proper mounting is essential. Although not difficult, and rings to your firearm. The Razor HD 1–6x24 riflescope requires the correct steps must be followed. If you are unsure of your 30 mm rings. abilities, it would be best to use the services of a qualified gunsmith.
RIFLESCOP Eye Relief and Reticle Alignment Sighting in the Rifle Before the final tightening of the scope ring screws, adjust for Bore Sighting maximum eye relief to avoid injury from recoil. Initial bore sighting of the riflescope will save time and money at the range. This can be done using a mechanical or laser bore To make the adjustment: 1. Set the riflescope to the middle of its magnification range. 2. Slide the riflescope as far forward as possible in the rings. 3.
RIFLESCOP Range Sight-In After bore-sighting the riflescope, select the exact ammunition you expect to hunt or shoot with and go to the range for the final sight-in. After completing the final sight-in: Remove the central screw. 1. While holding the elevation turret cap firmly between thumb 1. Be sure to follow all safe shooting practices. Before shooting, and forefinger to prevent any be sure the reticle is in focus (see Reticle Focus Adjustment on rotation, use the 2 mm hex wrench page 4).
RIFLESCOP Maintenance Troubleshooting Cleaning Sighting-in Problems The Razor HD riflescope requires very little routine maintenance Many times, problems thought to be with the scope are actually other than periodically cleaning the exterior lenses. The exterior of mount problems. Be sure the mounts are tight to the rifle and the the scope may be cleaned by wiping with a soft, dry cloth. scope is secured so it doesn’t twist or move in the rings.
RIFLESCOP The VIP Warranty We build optics based on our commitment to your absolute satisfaction. That’s why Vortex products are unconditionally guaranteed and we make this Very Important Promise to you—a Very Important Person. Rest assured that in the event your Razor HD Gen II riflescope becomes damaged or defective, Vortex Optics will repair or replace the riflescope at no charge to you. Call Vortex Optics at 800-426-0048 or e-mail service@vortexoptics.com for prompt, professional, and friendly service.
RIFLESCO PE www.vortexoptics.
