User Manual

5 4
S
p
ar
a
ar
p
c
®
RED DO T
red doT AdjuSTmenTS
Use a coin to remove the battery compartment cover. Install one CR 2354
battery so the “
+”
lettering faces
outward and replace the cover.
When replacing the cover, be sure
it is fully screwed down.
Battery Installation
Note: The typical life of the
CR 2354 battery depends on dot
intensity setting.
Waterproof Yes
Fogproof Nitrogen gas purging
Shockproof Yes
Eye Relief Unlimited
Dot Size 2
moa
Dot Color Red
Illumination Variable 10-position intensity
Night vision compatible mode
Parallax Parallax free past 50 yards
Magnification 1x
2x with included magnifier
Weight 5.2 ounces (without base)
Length 3 inches
Objective Diameter 22 mm
Ocular Diameter 22 mm
Included Accessories
2x Magnifier
Tall Riser
Short Riser
Riser Shim
(2) CR 2354 Batteries
Hex wrench
Windage 90 moa
Elevation 90 moa
Per Rotation 45 moa
Per Click 1 moa
Adjustment Specifications
Available Accessories
ARD filter
SPARC Specifications
To activate the illuminated dot press and release the Power button. While
in night vision compatible mode, the
illuminated dot will not be visible
unless a night vision device is being
used (see page 6).
To deactivate the illuminated dot,
press and hold the Power button for
five seconds.
Note: If you forget to turn the
SPARC off after use, it will automatically shut down in six hours.
Powering Up
Power Button
Battery Compartment
Red Dot Average Operating Time
Mode of Operation Normal Night Vision
Maximum Brightness 120 hours 4200 hours
Minimum Brightness 3400 hours 4600 hours
1300 hour average operating time