User's Manual

ManualsBrandsVortex ManualsOpticsAMG UH-1 Gen II Holographic Sight

PRODUCT MANUAL

Summary of content (9 pages)

PAGE 1
PRODUCT MANUAL 1
PAGE 2
AMG UH-1 GEN II ® ® HOLOGRAPHIC SIGHT MOUNT TYPE Picatinny MAGNIFICATION 1x DOT COLOR Bright Red DOT SIZE 1 MOA EYE RELIEF Unlimited ADJUSTMENT GRADUATION ½ MOA TRAVEL PER ROTATION 16.5 MOA MAX ELEVATION ADJUSTMENT 100 MOA MAX WINDAGE ADJUSTMENT 100 MOA PARALLAX SETTING Parallax Free LENGTH 3.9 inches (99mm) HEIGHT 2.7 inches (69mm) OPTICAL AXIS HEIGHT 41mm (Lower ¹⁄³ cowitness) WEIGHT 11 oz (0.
PAGE 3
AMG UH-1 GEN II ® ® HOLOGRAPHIC SIGHT OPERATING THE UH-1® GEN II Battery Information One CR123A battery powers the UH-1®. Shockproof Housing Note: If the reticle begins to pulse, the battery should be changed. Sight Window Installing/Replacing the Battery To remove the toolless battery cap, flip up the tab and turn the cap counterclockwise. Install the battery with the positve (+) end going into the unit. Replace the battery cap.
PAGE 4
AMG UH-1 GEN II ® ® HOLOGRAPHIC SIGHT Powering Up Night-Vision Button To turn the UH-1® on, press either the “+” or “-” button. Use the plus (+) and minus (-) buttons to adjust illumination levels. There are 15 illumination settings for daytime illumination and 4 night vision compatible settings. The UH-1® is night-vision compatible. The Night-Vision (NV) Button toggles the UH-1® to night-vision mode. There are 4 settings available in NV mode.
PAGE 5
AMG UH-1 GEN II ® ® HOLOGRAPHIC SIGHT Windage and Elevation Adjustments Integrated Quick-Release Mount Use a coin or other flat-head item to turn the elevation and windage dials to adjust for point of aim. For both adjustment dials, one click will change the point of aim approximately ½ MOA when zeroing. 1. To open the mount, depress the lock button and swing the Quick-Release Mount Lever 90 degrees to the open position. One full rotation of either dial will change the point of aim approximately 16.
PAGE 6
AMG UH-1 GEN II ® ® HOLOGRAPHIC SIGHT 4. To adjust the tension, move the lever back to the open position. Using a flat-head screwdriver or similar device, turn the adjustment nut (pictured) left or right to loosen or tighten (left-looser, righttighter). Make small adjustments of one or two clicks, then check lever closing tension. It may be necessary to repeat this process a few times until proper tension is achieved.
PAGE 7
AMG UH-1 GEN II ® ® HOLOGRAPHIC SIGHT FCC REQUIREMENTS The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes, or modifications not expressly approved by the party responsible for compliance, could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 8
AMG UH-1 GEN II ® HOLOGRAPHIC SIGHT Laser Safety Do not stare into beam or view directly without laser eye protection. Staring continuously into beam for prolonged periods of time could cause harm to your eyes. If used properly, this device is safe for your eyes and laser eye protection is not needed. • Use the correct battery (CR123A) and proper battery orientation. • Do not look at sun. VIP WARRANTY OUR UNCONDITIONAL PROMISE TO YOU. • Do not disassemble. • Do not allow children to play with unit.