User's Manual

AMG
®
UH-1
®
GEN II
HOLOGRAPHIC SIGHT
8 9
Windage and Elevation Adjustments
Use a coin or other flat-head item to turn the elevation
and windage dials to adjust for point of aim. For both
adjustment dials, one click will change the point of aim
approximately ½ MOA when zeroing.
One full rotation of either dial will change the point of
aim approximately 16.5 MOA—approximately 8.25" at
50 yards or 16.5" at 100 yards when zeroing.
Note: When adjusting, you may encounter increased resistance.
This means you’ve reached the end of the adjustment range and
you should not turn the dial any farther.
Elevation
Adjustment
Windage
Adjustment
One click yields 1/2 MOA of adjustment.
~1/8-inch (3.18mm) at 25-yds (22.9 m)
~1/4-inch (6.35mm) at 50-yds (45.7 m)
Integrated Quick-Release Mount
1. To open the mount, depress the lock button and
swing the Quick-Release Mount Lever 90 degrees to
the open position.
2. Position the UH-1
®
down onto the rail at desired
location. Place the lever side onto the rail first, then
rotate the unit so it is flush on the rail. Apply forward
(towards the muzzle) pressure on the unit. Move
mount lever back to closed position.
3. Check lever closing
tension. Lever
should close with
moderate pressure
using thumb or
finger. It should not
require excess force
to close. If lever
won’t close, closes
with excess force,
or seems extremely
easy to close with
little or no tension,
proceed to step 4.
Lock Button
Quick-Release
Mount Lever
Adjustment Nut
(Opposite Side)