CrossFireII II RIFLESCOPE RIFLESCOPE MANUAL 30 mm Diameter Main Tube
RIFLESCOPE II The Vortex® Crossfire II® Riflescopes Specifically designed for discriminating hunters and shooters, the Crossfire II®series of riflescopes offer the highest levels of performance and reliability. With features such as generous long eye relief, rugged construction and precise, smooth controls, the Crossfire II riflescopes are ready for any situation.
RIFLESCOPE II Riflescope Adjustments Windage and Elevation Adjustments Reticle Focus The Crossfire II riflescope incorporates adjustable elevation and windage Vortex Crossfire II riflescopes use a fast focus eyepiece designed to quickly dials with audible clicks. Each audible click moves the bullet’s point-of- and easily adjust the focus on the riflescope’s reticle. impact 1/4 of a minute of angle (MOA).
RIFLESCOPE II Image Focus and Parallax Correction Some of the Crossfire II riflescope models use an image focus/parallax adjustment which provides maximum image sharpness and eliminates parallax error. Lower power models do not use image focus/parallax adjustments and are pre-focused at a distance of 100 yards.
RIFLESCOPE II Riflescope Mounting Eye Relief and Reticle Alignment To get the best performance from your Crossfire II riflescope, proper Begin with riflescope loosely installed in rings on the rifle. Before mounting is essential. Although not difficult, the correct steps must be tightening the scope ring screws, adjust scope position for maximum followed. If you are unsure of your abilities, it would be best to use the eye relief to avoid injury from recoil. services of a qualified gunsmith.
RIFLESCOPE II Bore Sighting Final Range Sight-In Initial bore sighting of the riflescope will save time and money at the range. After the riflescope has been bore-sighted, final sight-in should be done at This can be done in a number of ways. A mechanical or laser bore sighter the range using the exact ammunition expected to be used while shooting. can be used according to the manufacturer’s instructions. On some rifles, Sight in and zero the riflescope at the preferred distance.
RIFLESCOPE II Indexing Adjustment Dials with Zero Reset Maintenance Crossfire II riflescopes feature windage/elevation dials that allow you to Cleaning re-index the zero indicator after sight-in without disturbing your settings.
RIFLESCOPE II Troubleshooting The VIP Warranty Sighting-in Problems We build optics based on our commitment to your absolute satisfaction. Many times, problems thought to be with the scope are actually mount That’s why Vortex products are unconditionally guaranteed and we make problems. Be sure that correct base and rings are being used in the correct this Very Important Promise to you—a Very Important Person. orientation, and that the base screws and rings are tight.
CrossFireII II RIFLESCOPE WWW.VORTEXOPTICS.
