User Guide

sunlight or strong ultraviolet light for extended periods of time. The headset contains lenses which
may focus and intensify bright light sources, causing damage to the hardware.
General Precautions
− Do not connect with incompatible peripherals.
− Do not attempt to disassemble this product.
− Use only qualified personnel to service or repair this product.
− Always treat the product with care and keep it in a clean and dust-free place.
− Avoid dropping the product. If dropped, especially on a hard surface, and the user suspects
damage, take it to an authorized service technician or provider for inspection.
− Do not expose the product to open flames or lit smoking products.
− Do not drop, throw or try to bend the product.
− Do not expose to liquid.
− Do not use harsh chemicals, cleaning solvents, liquid cleansers or aerosols to clean the
product.
− Do not paint the product.
− Store the product at temperatures between 0°C to 40°C
− Please check local regulations for proper disposal of electronic products.
− Avoid hot areas. The product should be placed away from heat sources such as radiators,
heat registers, stoves, or other products (including amplifiers) that produce heat.
− Avoid using the product after a dramatic change in temperature. When you move the
product between environments with very different temperature and/or humidity ranges,
condensation may form on or within the product. To avoid damaging the product, allow
sufficient time for the moisture to evaporate before using the product.
NOTICE: When taking the product from low-temperature conditions into a warmer environment
or from high-temperature conditions into a cooler environment, allow the product to acclimate
to room temperature before turning on power.
Damage Requiring Service
Contact an authorized service technician or provider under the following conditions:
− The product has been damaged by exposure to liquid, dropped, subject to impact or
damaged.
− There are noticeable signs of overheating.
− The product does not operate normally when you follow the operating instructions.
Cleaning the product
Unplug the product from other peripherals before cleaning. Use a damp cloth for cleaning, but
NEVER use water to clean the product. If there is any itching, eczema, swelling, irritation of the skin,
or you experience any discomfort, please discontinue use and consult your physician.
About vDongle regulatory agency identifications
For regulatory identification purposes, vDongle product is assigned a model number of VD-0001.
vDongle FCC ID is 2AQWO-VD0001. This FCC ID can also be found printed on the vDongle.
To ensure continued reliable and safe operation of vDongle, use only the accessories listed below
with your VD-0001: