User Manual

High Speed Blender
Operating manual
Thank you for your trust and support to our products!
Please use the corresponding model.
The product is subject to the material object.
Please read this manual carefully before use
and save it for future reference.
Product in the long-term start-up operation or use
in the presence of someone, such as long-term
or personnel leave, out of the plug please pull up.
There are still parts of the standby power on state, due to insulation
deterioration or leakage of electricity caused by fire.
Do not spray volatile oils, paints, insecticides on products.
Can cause electric shocks, fire accidents.
Be sure to pull off the plug when you are not in use for
a long time or when you are out of town.
Some of them are still energized during standby and may cause fire
accidents due to insulation cracking or leakage.
Do not pull off the power cord when pulling off the plug.
Always pull it off the plug.
Please make sure to plug in the power cord before use.
Make sure that the plug fits tightly with the socket.
There must be no loosening or incomplete insertion.
Do not trample on the power cord
Damage to the power cord or socket is the cause of leakage
and burns. If the power cord is damaged, it must be replaced
by the manufacturer or his service office or a similarly qualified
person to avoid danger.
Switch off the power when you are out or sleeping at night
The utility model can avoid the fire accident caused by
the wiring personalization and can save electricity.
Do not allow products to be inhaled or put into
combustible substances! And shall not be used
where mechanical oil composition floats
It can cause cracks, odors and fire accidents.
Do not use wet places such as bathrooms.
Can cause poor insulation. Causing a leakage or malfunction.
Do not use damaged power cords or plugs
This is the cause of electric shock, short circuit and fire.
Do not use multiple power cord sockets
Do not overheat or cause fire hazards by using extension cord
sockets or sharing power sockets with other electrical appliances.
Do not unplug the power cord with a wet hand
Do not risk electric shock by unplugging the plug with a wet
hand when the power supply needs to be unplugged.
Note:
Above are common trouble analysis and troubleshooting
methods. For other troubles, please contact our customer
service department, or go directly to our designated repair
point for repair. Do not dismantle and repair yourself.
N
L
Earthing
driving
circuit
power supply board
mixing
cup
motor
Safety
switch
Overload protector
Wiring is subject to change without prior notice
Speed
regulation
Ⅶ. Circuit Diagram
Ⅸ. Warning Items
Ⅷ. Fault Analysi
HS-206
Always pull off the plug when cleaning and maintaining.
Carefully scrub the cup body and lid with a sponge
or cloth and dry.
Do not put your hand into the cup for cleaning.
Wipe the rotating shaft and motor base with a dry
cloth (remember! Do not rinse with water).
When it is not easy to wipe, wipe it with neutral lotion,
and then wipe it with dry cloth until it is clean.
ⅤI. Cleaning and Maintenance Methods
Remember to pull off the plug when not in use.
Do not lift the lid of the cup until the stirring knife
has completely stopped rotating.
Be sure to separate the frame from the cup when
cleaning and make sure to pull off the plug first.
Do not immerse the motor base in water or put it in
the dishwasher for cleaning.
Keep a proper distance to prevent the child from
improper movement and causing danger when the
child is not allowed to be nearby during the start-up.
If the power cord is damaged, it must be replaced
by a professional in the manufacturer's maintenance
department or similar department in order to avoid danger.
V. Safety Matters
The blender
is not powered
The blender is
powered on but
does not work