User Manual

JamVOX owner’s manual
10
Performing with your guitar
Tuning your guitar — TUNER
1
In the effect routing area, click TUNER to select it.
The tuner will appear in the effect control panel.
2 If necessary, click the CALIB buttons ( ππ
ππ
/ ††
††
) to specify the calibration.
The calibration is the reference frequency used for tuning (expressed
as the frequency of the middle A note of a piano, A4). You can adjust
this in a range of 410–480 Hz. By default, this is 440 Hz.
3
Play a single note on your guitar, and tune the pitch approximately, so
that the desired note name appears in the display.
The display will show the note name that is closest to the pitch you
played.
NOTE: If you want to tune without producing sound, click the MUTE
button.
4
Use the LED meter to tune your guitar precisely.
Tune the string so that only the center LED is lit. The illumination in
the LED meter will move to the right of center if the pitch is sharp, or
to the left if the pitch is flat.
Changing the character of your guitar —
PICKUP SELECTOR
The pickup selector simulates the characteristics of various guitar pick-
ups, allowing you to modify the pickup tone of your connected guitar.
ON/OFF
Turns the pickup selector on/off.
If this is on, the pickup selector will be enabled
for all guitar programs.
TYPE
Selects the type of pickup.
Hum (Humbucker) > Single: Transforms the sound of a humbucking
pickup to that of a single coil pickup.
Single > Hum (Humbucker) : Transforms the sound of a single coil
pickup to that of a humbucking pickup.
Half Tone: Produces a “half tone” sound.
Phase Out: Produces the sound of pickups wired out of phase.
TONE
Adjusts the sound of the pickup type selected by “TYPE.” The result will
depend on the pickup type.
CALIB button
LED meter