User Manual
Table Of Contents
- Table of Contents
- Introduction
- Panel Tour for the guitarist (Top and rear panels)
- Making connections
- Trying out the programs
- Creating your own sounds
- Saving a program
- About the amp models, cabinet models, and effect types
- Tuner
- Using the expression pedal for control
- Connecting to your computer (USB connection)
- Restoring the factory settings
- Troubleshooting
- Preset program list
- Specifications
8
Making connections
Here’s how to make connections and start using your ToneLab ST.
1.
Set the AMP/LINE switch appropriately for the type of
device you’ll be connecting to the OUTPUT/PHONES jack.
Set the AMP/LINE switch as follows.
AMP (VOX, F, M)
If you’re connecting a guitar amp, choose the VOX, F, or M
setting. This setting will compensate the output from the
amp model as necessary. However, compensation will not
be applied if the amp model is off.
•
VOX:
Use this setting if the output is connected to an amp
that has a distinctive mid-range such as the AC30 open-
backed combo amp made by the VOX Corporation.
•
F:
Use this setting if the output is connected to a typical
clean-sounding US-made open-backed combo amp.
•
M:
Use this setting if the output is connected to a stack-
type amp such as a 4x12 closed-back cabinet.
LINE
Use this setting if the output is connected to your guitar
amp’s power amp, to an audio system, mixer, or recorder,
or to headphones.
2.
Use a cable to connect the ToneLab ST’s OUTPUT/PHONES
jack to your guitar amp, mixer, or other device.
NOTE:
Lower the volume of your guitar amp or mixer before
you make connections.
The OUTPUT/PHONES jack is a stereo output. Use a phone
plug to make connections.
OUTPUT/PHONES INPUT
AC adapter
DC12V
CD player, etc.
AUX
IN
USB
Audio system
Mixer, recorder, etc.
Computer
USB cable
Guitar
Guitar amp
Headphones
VOX