User Manual

5
5. Program Select / Tuner section
a. UP/DOWN pedals and LEDs
Selecting a program (p.9, “Trying out the programs”)
Pressing the UP pedal will increment the program by one, and
pressing the DOWN pedal will decrement the program by one.
You can hold down the UP pedal and press the EXIT/TUNE key
to increment the program by ten.
You can hold down the DOWN pedal and press the EXIT/TUNE
key to decrement the program by ten.
Using the tuner (p.23, “Tuner”)
If you press the UP and DOWN pedals simultaneously, all
effects will be bypassed and you’ll be able to use the tuner.
If you hold down the UP and DOWN pedals simultaneously for
about two seconds, you’ll be able to use the tuner with the
sound muted.
When you’re using the tuner, the LEDs will indicate the tuning
status.
6. Setting/Display section
a. Program (value) display
Normally this shows the program number.
When you’re using the tuner, this shows the
note name.
When you’re editing a parameter, this shows
the parameter value you’re editing.
If the parameter value matches the original
value, the decimal point segment in the lower
right of the LED will momentarily go dark
(p.11, “Parameter original value indication”).
b. WRITE switch
Press this if you saves the sound you’ve edited (p.12, “Saving a
program”).
c. EXIT/TUNE switch
Press this if you decide to cancel an operation (such as saving a
program).
When the CABINET switch LED, the QUICK ASSIGN LED, or
the program display are not blinking, you can press this switch
to use the tuner (p.23, “Tuning procedure”).
By holding down this switch for about two seconds, you can acti-
vate the
Key Lock function , which locks disables the operations
of the switches, selectors, and knobs on the top panel. To deacti-
vate this function, hold down the switch once again for about two
seconds.