User Manual

25
Resampling
Specifying how the loop will
stop
You can specify how the loop will stop when you press the
STOP pedal during loop playback.
1.PresstheSTOPMODEbutton.
Each time you press the button, the setting will alternate
as follows.
Buttonunlit:When you press the STOP pedal, the phrase
will stop immediately.
Buttonlit-upred:When you press the STOP pedal, the
phrase will stop and delay will be applied.
Buttonlit-uporange: When you press the STOP pedal, the
phrase volume will fade out, and the phrase will stop
when the volume reaches zero.
Buttonlit-upgreen: When you press the STOP pedal, the
phrase will play to the end and then stop.
Hint:When fading-out and then stopping, or when
playing the phrase to the end and then stopping, the
LOOP STATUS LED will rapidly blink green until the loop
stops.
You can’t record/overdub/resample until the loop stops.
Resampling
While a loop plays back, you can use the Loop Effect or the
control pedal to modify the phrase while re-recording the
result. This is called “resampling.”
By using resampling, you can apply more than one Loop
Effect, or create a loop of a different length than an already-
recorded loop.
Resampling is possible when applying the Loop Effect to
a loop-recorded phrase. You can’t resample unless a
phrase has already been recorded in a loop.
1.SimultaneouslypresstheSTOPpedalandthe
PROGRAMUPpedaltoselectaloopthathasbeen
recorded.
2.PresstheREC/PLAY/OVERDUBpedaltoplaybackthe
loop,andusethePROGRAMUPpedaltoselectthe
programthatgivesyouthesoundthatyouwant.As
desired,youcanedittheeffectparametersorusethe
controlpedaltoapplytheLoopEffect.
) p.18 “Playing programs”
When you play back a loop with the Loop Effect turned
on, the RESAMPLING STATUS LED will blink, indicated
that resampling is available.
3.PresstheREC/PLAY/OVERDUBpedal.
The RESAMPLING STATUS LED will light-up, and
resampling will start. The phrase with the Loop Effect
applied will be resampled.