User Manual
Table Of Contents
- English
- Table of contents
- Introduction
- Panels
- Connect your instrument and turn on the power
- Playing programs
- Creating phrases
- Overdubbing a performance by playing along with a recorded phrase
- Applying the Loop Effect to a recorded phrase
- Specifying how the loop will stop
- Resampling
- Applying the limiter to the recorded phrases
- Erasing a loop-recorded phrase
- Loop status
- About the Pre Effect and the Loop Effect
- Control pedal settings
- Restoring the factory settings
- Auto Power-Off function
- Troubleshooting
- Block diagram
- Main specifications
- Français
- Sommaire
- Introduction
- Panneaux
- Connexion de l’instrument et mise sous tension
- Jouer avec des programmes
- Créer des phrases
- Ajout d’un nouvel enregistrement à une phrase
- Traiter une phrase enregistrée avec un effet de boucle
- Mode d’arrêt de la boucle
- Rééchantillonnage (Resampling)
- Traiter les phrases enregistrées avec le limiteur
- Effacer la phrase d’une boucle
- Etat de la boucle (Loop Status)
- Pré-effets et effets de boucle
- Réglages de la pédale d’expression
- Rétablir les réglages d’usine
- Coupure automatique d’alimentation
- Dépannage
- Schéma de principe
- Fiche technique
- Deutsch
- Inhaltsübersicht
- Vorweg
- Bedienelemente
- Anschließen des Instruments und einschalten
- Spielen von Programmen
- Aufzeichnen von Phrasen
- Ergänzen einer Phrase um weitere Parts
- Bearbeiten aufgezeichneter Phrasen mit dem Loop-Effekt
- Festlegen, wie die Schleife endet
- Resampling
- Bearbeiten aufgezeichneter Phrasen mit dem Limiter
- Löschen einer Loop-Phrase
- Loop-Status
- Über den Pre- und Loop-Effekt
- Einstellungen für das Expression-Pedal
- Laden der Werkseinstellungen
- Energiesparfunktion
- Fehlersuche
- Blockschaltbild
- Wichtigste technische Daten
34
VOX Dynamic Looper Owner's manual
If you choose bAr, the previously specified time signature
and tempo will be used. With other settings, the tempo
will be used.
bAr: 1 measure 1-8: (eighth notes)
1-2: (two beats = half note) 1-12: 3 (eighth note triplets)
3-8: (one and a half beats) 1-16: (16th notes)
1-3: 3 (half note triplets) 1-24: 3 (16th note triplets)
1-4: (1 beat = quarter note) 1-32: (32nd notes)
3-16:
(
dotted eighth notes)
1-64: (64th notes)
1-6: 3 (quarter note triplets)
• Control pedal: Plays back a short phrase in synchronization
with the tempo. As you advance the pedal, the length of the
phrase will again be reduced by 1/2.
Ptc: PITCH
This is a pitch shifter that uses the control pedal to control
the pitch.
• EDIT knob: Specifies the range over which the pitch can
be controlled.
u57:As you advance the pedal, the pitch will change from
the original pitch → 5 semitones up → 7 semitones up.
u12:
As you advance the pedal, the pitch will change from
the original pitch → 1 semitone up → 2 semitones up.
u13:
As you advance the pedal, the pitch will change from
the original pitch → 1 semitone up → 3 semitones up.
u35:
As you advance the pedal, the pitch will change from
the original pitch → 3 semitones up → 5 semitones up.
u47:
As you advance the pedal, the pitch will change from
the original pitch → 4 semitones up → 7 semitones up
.
u24:
As you advance the pedal, the pitch will change from
the original pitch → 2 semitones up → 4 semitones up.
u5t:
As you advance the pedal, the pitch will change from
the original pitch → 5 semitones up → 10 semitones up.
ubn:As you advance the pedal, the pitch will rise
smoothly by a maximum of one octave.
uch: As you advance the pedal, the pitch will rise in
semitone steps by a maximum of one octave.
d57: As you advance the pedal, the pitch will change from
the original pitch → 5 semitones down → 7 semitones down.
d12:As you advance the pedal, the pitch will change from
the original pitch →1 semitone down → 2 semitones down.
d35: As you advance the pedal, the pitch will change from
the original pitch → 3 semitones down → 5 semitones down.
d47: As you advance the pedal, the pitch will change from
the original pitch → 4 semitones down → 7 semitones down.
d24:
As you advance the pedal, the pitch will change from the
original pitch → 2 semitones down → 4 semitones down.
dbn: As you advance the pedal, the pitch will fall
smoothly by a maximum of one octave.
dch: As you advance the pedal, the pitch will fall in
semitone steps by a maximum of one octave.
• Control pedal: Controls the pitch of the loop.