User Manual
Table Of Contents
- English
- Table of contents
- Introduction
- Panels
- Connect your instrument and turn on the power
- Playing programs
- Creating phrases
- Overdubbing a performance by playing along with a recorded phrase
- Applying the Loop Effect to a recorded phrase
- Specifying how the loop will stop
- Resampling
- Applying the limiter to the recorded phrases
- Erasing a loop-recorded phrase
- Loop status
- About the Pre Effect and the Loop Effect
- Control pedal settings
- Restoring the factory settings
- Auto Power-Off function
- Troubleshooting
- Block diagram
- Main specifications
- Français
- Sommaire
- Introduction
- Panneaux
- Connexion de l’instrument et mise sous tension
- Jouer avec des programmes
- Créer des phrases
- Ajout d’un nouvel enregistrement à une phrase
- Traiter une phrase enregistrée avec un effet de boucle
- Mode d’arrêt de la boucle
- Rééchantillonnage (Resampling)
- Traiter les phrases enregistrées avec le limiteur
- Effacer la phrase d’une boucle
- Etat de la boucle (Loop Status)
- Pré-effets et effets de boucle
- Réglages de la pédale d’expression
- Rétablir les réglages d’usine
- Coupure automatique d’alimentation
- Dépannage
- Schéma de principe
- Fiche technique
- Deutsch
- Inhaltsübersicht
- Vorweg
- Bedienelemente
- Anschließen des Instruments und einschalten
- Spielen von Programmen
- Aufzeichnen von Phrasen
- Ergänzen einer Phrase um weitere Parts
- Bearbeiten aufgezeichneter Phrasen mit dem Loop-Effekt
- Festlegen, wie die Schleife endet
- Resampling
- Bearbeiten aufgezeichneter Phrasen mit dem Limiter
- Löschen einer Loop-Phrase
- Loop-Status
- Über den Pre- und Loop-Effekt
- Einstellungen für das Expression-Pedal
- Laden der Werkseinstellungen
- Energiesparfunktion
- Fehlersuche
- Blockschaltbild
- Wichtigste technische Daten
38
VOX Dynamic Looper Owner's manual
Saving a program
The PRE FX TARGET setting (the choice of input to which
the Pre Effect will apply), the Pre Effect that modifies the
sound of your guitar, the Loop Effect that modifies the loop
phrase(s) being played back, and the control pedal
assignment are saved together as a program.
If you’ve edited the contents of a program, and then
selected another program or turned off the power before
saving the modified program, the settings that you
edited will return to their original state. If you want to
keep the changes that you made, you must save the
program as follows.
1.PresstheWRITEbutton.
The indication in the program/value display will blink. If
you were editing a preset program, a user program
number will appear.
2.UsetheEDITknobtospecifythewriting-destination
userprogram.
Your program will be saved by overwriting the
destination program that you specified. Take care not to
overwrite an important program that you want to keep.
It’s not possible to save your program to a preset program.
3.PresstheWRITEbuttononceagain.
Your new program will overwrite the user program you
specified in step 2, and the program/value display will
change back from blinking to steadily lit.
Note: When you write a program, the Dynamic Looper
will be in the same state as immediately after you selected
the writing-destination program. If you wrote the
program while using the control pedal to control the Loop
Effect, the Loop Effect will be temporarily disabled.