User Manual
Table Of Contents
- English
- Table of contents
- Introduction
- Panels
- Connect your instrument and turn on the power
- Playing programs
- Creating phrases
- Overdubbing a performance by playing along with a recorded phrase
- Applying the Loop Effect to a recorded phrase
- Specifying how the loop will stop
- Resampling
- Applying the limiter to the recorded phrases
- Erasing a loop-recorded phrase
- Loop status
- About the Pre Effect and the Loop Effect
- Control pedal settings
- Restoring the factory settings
- Auto Power-Off function
- Troubleshooting
- Block diagram
- Main specifications
- Français
- Sommaire
- Introduction
- Panneaux
- Connexion de l’instrument et mise sous tension
- Jouer avec des programmes
- Créer des phrases
- Ajout d’un nouvel enregistrement à une phrase
- Traiter une phrase enregistrée avec un effet de boucle
- Mode d’arrêt de la boucle
- Rééchantillonnage (Resampling)
- Traiter les phrases enregistrées avec le limiteur
- Effacer la phrase d’une boucle
- Etat de la boucle (Loop Status)
- Pré-effets et effets de boucle
- Réglages de la pédale d’expression
- Rétablir les réglages d’usine
- Coupure automatique d’alimentation
- Dépannage
- Schéma de principe
- Fiche technique
- Deutsch
- Inhaltsübersicht
- Vorweg
- Bedienelemente
- Anschließen des Instruments und einschalten
- Spielen von Programmen
- Aufzeichnen von Phrasen
- Ergänzen einer Phrase um weitere Parts
- Bearbeiten aufgezeichneter Phrasen mit dem Loop-Effekt
- Festlegen, wie die Schleife endet
- Resampling
- Bearbeiten aufgezeichneter Phrasen mit dem Limiter
- Löschen einer Loop-Phrase
- Loop-Status
- Über den Pre- und Loop-Effekt
- Einstellungen für das Expression-Pedal
- Laden der Werkseinstellungen
- Energiesparfunktion
- Fehlersuche
- Blockschaltbild
- Wichtigste technische Daten
42
VOX Dynamic Looper Owner's manual
Troubleshooting
Power won’t turn on
• Is the included AC adapter connected to the rear panel
DC9V jack?
• Is the AC adapter connected to an AC outlet?
• Could the AC outlet be faulty?
• Could the AC adapter be malfunctioning?
• Is the STANDBY switch in the ON position?
No sound
• Is your instrument correctly connected to the Dynamic
Looper’s INPUT jack?
• Could the cable be broken?
• Could the volume be turned down on the instrument
that’s connected to the INPUT jack?
• If you’re using a mic, is the MIC TRIM knob set correctly?
• Could the volume be assigned to the foot control pedal,
and the pedal be in the fully returned position?
Loop won’t play back
• Have you selected a loop that contains a recorded phrase?
Effect won’t apply
• Is the effect turned on?
• The Loop Effect will apply only if something is recorded
on Loop 1 or Loop 2.
• Could the control pedal be assigned to volume?
• Check the Loop Effect settings.
Something is wrong with the sound
• Check the Loop Effect settings.
Operating the pedals, buttons, selectors, or knobs
does not change the sound
• Could the effect be turned off?
• Could the Key Lock function be enabled?
Power turns off unexpectedly
• The Dynamic Looper has an Auto Power-Off function that
automatically turns off the power when four hours have
elapsed since the most recent user input. If you want to
disable the Auto Power-Off function, please refer to
“Disabling the Auto Power-Off function” on page 41.