Owner`s manual

20
VOX Lil' Looper Owner's manual
Initiating recording when you start playing
(Auto Recording Start)
The Auto Recording Start function makes recording
begin the moment you start playing.
1. PresstheAUTORECbuontomakeitlight-up.
2. Whileholdingdown the AUTO REC buon,
turntheLOOPLEVEL/VALUEknobtosetthe
sensitivitywheretherecordingwillbegin.
Turning the knob counterclockwise will increase
the sensitivity, and turning the knob clockwise will
decrease it.
If the sensitivity is increased, the recording will
start at a low input level.
The sensitivity seing is saved even if the power
is turned o.
3. Pressthepedalofthelooptoberecorded.
The REC status LED will blink red.
The Auto Recording Start function will turn on,
and the Lil' Looper will be in record-standby mode.
4. Playyourinstrument.
Recording will begin the moment you start playing.
During recording, the REC status LED will light-
up red.
Recording on Loop 2
Now let’s record a phrase on Loop 2.
1. Asdesired,youcanalsoadjusttheeectpa-
rameters.
) p. 15 “Recording on Loop 1”
2. PresstheLOOP1pedaltoplaybackLoop1.
3. Atthedesiredmoment,presstheLOOP2pedalto
startrecording.
Hint: If you press the LOOP2 pedal while recording
Loop 1, Loop 1 will switch to playback and Loop 2
will start recording.
4. Whenyou’veplayedaslongasyouwantthe
looptobe,presstheLOOP2pedal.
Recording will end, and the loop will switch to
loop playback.
Note: The operations when the tempo is set
and a recording is performed are dierent from
the operations when the tempo is not set and a
recording is performed.
)
p. 18 “Using the metronome as a guide while you
record”