Owner`s manual

13
Troubleshooting
The amp isn’t powering up when the STANDBY switch
is ON.
• Haveyouinstalledbaeries?Isthepolaritycorrect?
Or,istheACadaptercordconnectedtotherearpanel
oftheampcorrectly?
• IstheACadapterpluggedintoanACoutlet?
• IstheACoutletswitchedonandworking?
• IstheACadapterdamaged?
There’s no sound coming from the amp
• Isyourguitarturnedup?
• Arebothendsofyourguitarcablepluggedintowhere
theyshouldbe?
• Isyourguitarcableworking?
• Are the top panel MASTER volume and GAIN knob
turnedup?
•Doyouhaveheadphonesoranythingelsepluggedinto
theamp’stoppanelPHONESjack?If“yes,”unplug!
The amp doesn’t seem very loud
• Isyourguitarturnedup?
• IsthetoppanelMASTERvolumeorGAINknobturned
downlow?
There’s no sound heard from the PHONES jack when
you use it.
• CheckthatthetoppanelMASTERvolumeisn’tturned
allthewaydown.
• Makesuresoundiscomingfromtheamp.
You’llneedtounplugyour headphonesorcablefrom
thePHONESjacktodothis,sincepluggingsomething
intothisjackautomaticallymutestheamp’sspeakers.
If there’s still no sound from the amp, go to “There’s
nosoundcomingfromtheamp.”Ifyoudohearsound,
checktheheadphonesorcableyouarehookingupto
thisjack.
The effects cannot be applied to the sound.
• Isthetunerfunctionturnedon?
If the tuner function is turned on, the eects will be
bypassed.PresstheTAPswitchtocancelthebypassing
oftheeects.
•
IstheEFFECTSorDELAY/REVERBknobsettoOFForto
alowervalue?
AdjusttheEFFECTSandDELAY/REVERBknob.
• IftheeectscannotbeappliedtotheMICsignal,theDLY/
REVSENDknobmightbesettoalowervalue.Adjust
theDLY/REVSENDknob.