Quick Installation Guide

5
2.3 Connecting AC power
2.3.1 Pull an AC cable (mains power – 110VAC) to Sensor Unit.
2.3.2 Release 4 captive screws on back compartment and open cover.
2.3.3 Slide AC cable through open cable gland on back compartment
cover. Then connect AC cable to AC inlet, as shown:
2.3.4 Close back compartment cover, tighten 4 captive screws and then
tighten cable gland firmly on AC cable.
2.4 Aiming the Sensor Unit
2.4.1 Move Sensor Unit Up/Down and Left/Right, according to
instructions over the phone from NoTraffic’s NOC.
2.4.2 When NoTraffic’s NOC says Sensor Unit is aimed, tighten two
bolts on Astro-Brac to lock Sensor Unit in position.
2.5 Finishing installation
2.5.1 Check for mechanical integrity of the Sensor Unit and Astro-Brac.
2.5.2 Attach excess AC cable to pole, using cable ties.
AC inlet Fuse Technician RJ45 port